Thingiverse
Badge and RSA token holder by jpwhips
by Thingiverse
Last crawled date: 4 years, 5 months ago
Remixed one of the YK42 ... Some things I impoved:
The hole at the top was too small, I widened it.
Reinforced the hole at the top (rounded and widened).
Move the hole up ~1mm so my badge would 'sit' in the slot.
The last change may be what is a problem for some as this makes the id badge a very tight fit. I will need needle nose pliers to remove it.
The hole at the top was too small, I widened it.
Reinforced the hole at the top (rounded and widened).
Move the hole up ~1mm so my badge would 'sit' in the slot.
The last change may be what is a problem for some as this makes the id badge a very tight fit. I will need needle nose pliers to remove it.