Thingiverse
Axial Unimog SCX10.II Snow Plow
by Thingiverse
Last crawled date: 5 years, 4 months ago
This is a snow plow for the Axial SCX10.II (SCX10.2) Unimog UMG10.
Theoretically, this should bolt on to any SCX10.II axle and frame, but you'll need some shims/washers for the upper frame mount maybe.
I added the Winch mount version which i had forgotten to upload!
Bolts to the axle for best strenght when pushing snow.
Upper frame for a servo mount, required only if you don't have a winch or something else to raise the plow.
Has a set of shoes that are height adjustable.
The lower frame has a set of M3 screws that you can adjust to limit the blade angle to what you like.
It should not restrict your turn radius unless you have big tires.
Requires :
45mm pull spring or a shock in droop setup that pulls instead of push, for the plow safety mechanism. You can use a hard link if you want.
Dozen M3x20 screws
Couple M3x16 screws
Handfull of M3 nuts
Servo or winch
Theoretically, this should bolt on to any SCX10.II axle and frame, but you'll need some shims/washers for the upper frame mount maybe.
I added the Winch mount version which i had forgotten to upload!
Bolts to the axle for best strenght when pushing snow.
Upper frame for a servo mount, required only if you don't have a winch or something else to raise the plow.
Has a set of shoes that are height adjustable.
The lower frame has a set of M3 screws that you can adjust to limit the blade angle to what you like.
It should not restrict your turn radius unless you have big tires.
Requires :
45mm pull spring or a shock in droop setup that pulls instead of push, for the plow safety mechanism. You can use a hard link if you want.
Dozen M3x20 screws
Couple M3x16 screws
Handfull of M3 nuts
Servo or winch