Thingiverse
Automatic gopro timelapse maker
by Thingiverse
Last crawled date: 5 years, 11 months ago
This is a turner designed to take dynamic timelapses in a gopro.
What you need:
Inside the case is an arduino uno (code is below) and a standard size servo ( i used a hitec HS-422 that i had laying around). I used a solder connection arduino hat - (not sure of correct name but shown in pictures) to make the connections easier.
You will also need a potentiometer and two leds. The system is powered using a 12V lipo that plugs in to the connecion on he outside. - when this is connected the turning will start immediately.
Assembly:
I have attatched a wiring diagram
The servo and leds were attatched with hot glue and the bottom plate was attatched with a soldering iron - just melted the two parts together.
I have included the f360 file if you want to make any changes.
Using;
The gopro needs to be programmed so it takes a photo every X many seconds. he speed of rotation can be altered untill you find the best combination. One of the leds will flash every time it moves and the other will flash when it reaches the end of its travel
Code: -is attached there is two lots. When i was using this my cheap potentiometer failed so i modified the code so the pot did not alter the speed
What you need:
Inside the case is an arduino uno (code is below) and a standard size servo ( i used a hitec HS-422 that i had laying around). I used a solder connection arduino hat - (not sure of correct name but shown in pictures) to make the connections easier.
You will also need a potentiometer and two leds. The system is powered using a 12V lipo that plugs in to the connecion on he outside. - when this is connected the turning will start immediately.
Assembly:
I have attatched a wiring diagram
The servo and leds were attatched with hot glue and the bottom plate was attatched with a soldering iron - just melted the two parts together.
I have included the f360 file if you want to make any changes.
Using;
The gopro needs to be programmed so it takes a photo every X many seconds. he speed of rotation can be altered untill you find the best combination. One of the leds will flash every time it moves and the other will flash when it reaches the end of its travel
Code: -is attached there is two lots. When i was using this my cheap potentiometer failed so i modified the code so the pot did not alter the speed