Thingiverse
Automated Sprouter parts by chuckv3
by Thingiverse
Last crawled date: 4 years, 1 month ago
Legs and a drain attachment for making an automated sprouter from any plastic container(s) as seen in my youtube video here: https://www.youtube.com/watch?v=OY2Ezu5GYMo
The outer container is a store-bought item about 8" deep, 12" wide and 9" tall. These legs allow it to tilt toward one corner, where you install the drain piece. all parts go on the outside. It's snug enough to prevent leaks since this is a low-water-pressure application. The sprouter trays are containers from Ikea (three pack of food-grade containers with lids, about 5" wide, 7" long and 2" tall).
These are best attached with stainless steel pan-head bolts, #4 x 1/4" (you need 6 bolts and 6 nuts). I used bolt depot product# 6902 and 4115 (as pictured).
For complete parts and assembly, please check out the youtube video.
The outer container is a store-bought item about 8" deep, 12" wide and 9" tall. These legs allow it to tilt toward one corner, where you install the drain piece. all parts go on the outside. It's snug enough to prevent leaks since this is a low-water-pressure application. The sprouter trays are containers from Ikea (three pack of food-grade containers with lids, about 5" wide, 7" long and 2" tall).
These are best attached with stainless steel pan-head bolts, #4 x 1/4" (you need 6 bolts and 6 nuts). I used bolt depot product# 6902 and 4115 (as pictured).
For complete parts and assembly, please check out the youtube video.