Thingiverse
Athorbot Buddy 60mm Fan Adapter V1 by Pitdad
by Thingiverse
Last crawled date: 4 years, 3 months ago
Havent printed it yet but will be tomorrow. Should Be able to print with supports if your printer is dialed in and have bridge settings enabled. or just print with supports. will post results.
UPDATE 9/8/2018: V1 will not work but still leaving it up for those intereseted. looking as if X axis Limit switch will need relocated to the back of the carriage (works fine). Head of the bolt or nuts interfer with LS actuation. Keaving this up incase somebody finds an application for it.
V2 has the 60MM Fan recessed 3mm to allow clearance for the switch. Also 3mm screws thread right in. will be printing tomorrow.
printed first version in PLASFIL PLA+ Have found that this acts similar to ABS and requires nearly no cooling fan and a 70* bed.
UPDATE 9/8/2018: V1 will not work but still leaving it up for those intereseted. looking as if X axis Limit switch will need relocated to the back of the carriage (works fine). Head of the bolt or nuts interfer with LS actuation. Keaving this up incase somebody finds an application for it.
V2 has the 60MM Fan recessed 3mm to allow clearance for the switch. Also 3mm screws thread right in. will be printing tomorrow.
printed first version in PLASFIL PLA+ Have found that this acts similar to ABS and requires nearly no cooling fan and a 70* bed.