Aruino Uno Case by endlessloop

Last crawled date: 3 years ago

Made this for a pump controller project I had, so a little specific in it's use case (RGB support, molex, buttons), but figured maybe somebody else could use it. Fits an arduino uno, relay module, two buttons, and an lcd screen. Cutout for molex which I used for pump interface. Used PC 2.5" drive screws for all of it. Bottom needs supports but if anybody wants it without the feet I can load that as well. Supports will be needed for the span on the lcd cutout. I used glue to put it together as friction fit was not strong enough and screw cutouts were taking up too much space.