Arrma Granite 3S BLX v2 TPU Wing Mount by caracalrc

Last crawled date: 3 years, 1 month ago

This is a remix of the already great Arrma 3s/4s TPU Wing Mount.
For the Arrma Granite 3S BLX v2, the following issues of the above "thing" have been fixed :
Space between holes that goes around the body post towers was too high, so I reduced it to exactly the space there is between them (24 mm between the center of them).
As the original part from Arrma, the body post couldn't be pushed as far as it should be once the wing mount is installed on this specific car, so the body was siting higher than expected and the wing was a little to low compared to it.
Some new holes had to be done on the truck for the screws of the body post. This is not needed anymore, the existing ones can be reused.
As the original thing, materials required for wing mount assembly is:
(3) M3x40mm screws
(3) M3 locknuts
(3) M3 washers (used under the M3 locknuts, optional but recommended)
This is my first remix/design, with blender, I hope this will help someone. It helped me at least.
Note: Photos show a print with TPE filament that almost failed (the left part of the wing mount), that's why the two parts are not stuck well. It works anyway. Your print should be much better than mine.