Thingiverse
Armattan Chameleon / Rooster ImmersionRC Tramp VTX SMA antenna mount by nevinleiby
by Thingiverse
Last crawled date: 4 years, 7 months ago
I was sick of the ImmersionRC Tramp not seating properly against the standard chameleon backplate. It would pull back inward or drag along the frame and distort the signal. This mount allows the VTX to be firmly seated against the rear and allows the VTX sma adapter to allow for the antenna to be tightened without any twisting of the internal connector.
I printed using PLA and it worked just fine. PETG or TPU would probably be ideal. No supports needed, the internal shield can be extended to provide more coverage, the internal plate can be used for mounted or removed if it's in the way. I use Crossfire mounted on the rear arm, but the receiver antenna mounts are there as well.
Enjoy this model as well as the TBS Unify variant.
I printed using PLA and it worked just fine. PETG or TPU would probably be ideal. No supports needed, the internal shield can be extended to provide more coverage, the internal plate can be used for mounted or removed if it's in the way. I use Crossfire mounted on the rear arm, but the receiver antenna mounts are there as well.
Enjoy this model as well as the TBS Unify variant.