Thingiverse
Arduino thermometer enclosure
by Thingiverse
Last crawled date: 5 years, 4 months ago
This is an enclosure to build your own room climate display.
It holds the following components:
1x Micro-USB Port for power in (like this)
1x Arduino Nano (I used this one
1x DHT11 temperature and humidity sensor (I used this one)
1x GY-68 BMP180 barometric and temperature sensor (I used this one)
1x 0.96" 128x54 pixels OLED display (I used this one)
To hold the display, the front was remixed from Ybot_1's Display Frame.
I used some black tape to mask the Arduino's on-board LEDs to avoid them from shining through as I printed it using white PLA.
It holds the following components:
1x Micro-USB Port for power in (like this)
1x Arduino Nano (I used this one
1x DHT11 temperature and humidity sensor (I used this one)
1x GY-68 BMP180 barometric and temperature sensor (I used this one)
1x 0.96" 128x54 pixels OLED display (I used this one)
To hold the display, the front was remixed from Ybot_1's Display Frame.
I used some black tape to mask the Arduino's on-board LEDs to avoid them from shining through as I printed it using white PLA.