ARDUINO Robotic Motor Project Controls - Lego Meccano Compatible by jlsilicon

Last crawled date: 3 years, 1 month ago

Finally Computer / MICRO Controller for these ROBOTs.
I built Cases and Mounts and CODE for using the ARDUINO in these Projects.
This setup is assuming an Arduino, Battery, Motor Drivers, Power/Switches, LEDs, etc...
This is intended to Automate the MOTORs and ROBOTs for user Projects.
Will post ANIMAL / ROBOT BEHAVIOR Code also.
Parts include:
Arduino Case , Deep with Slots - found that I don't use the Top part.
Battery Case.
LEDs + Switches Panel.
OLED/LCD Panel - found that I used the Top / but not the Bottom part.
Motor Drivers Case.
Motor Drivers:
See:http://forum.arduino.cc/index.php?topic=416534
Schematic is attached above.
SCHEMATIC +
CODE +
UNDER CONSTRUCTION:
This is waiting for the SCHEMATICS and CODE.
COMING SOON ...
This is a set of Struts that I composed. These are 3D shaped , in contrast to the Meccano Parts that are 2D in that they are Flat / paper-like based. They are still compatible with the Meccano and Motor Converter Parts that I posted here on other Pages.
Parts included are: Motor Gear Mounts, Motor Mounting Sleeves, Jaws, ClawNails, Feet, Curves, etc.
These are compatible with the Meccano and Motor Parts (as mentioned earlier) , including:
Meccano Base Parts Plates Struts Angles ,
Geared MOTORs to Meccano and Lego Conversion - Kit Parts
for additional parts.