Thingiverse
Arduino Nano case with completely accessible pins by nspohrer
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a two-part case for Arduino Nanos or clones of it (as featured in the pictures). It is similar to a design by spradlinb, but made from sketch.
Features
The two halves just clip together, if printed with the right clearance (see Instructions)
USB port accessible
All top and bottom pins accessible as far as the plastic part of the pin headers
Top 6 pins do not protrude from the case
Arduino board is held in place by four small pillars
The Arduino Nano 3D model was created by Andrew Whitham (https://grabcad.com/library/arduino-nano--1).
Features
The two halves just clip together, if printed with the right clearance (see Instructions)
USB port accessible
All top and bottom pins accessible as far as the plastic part of the pin headers
Top 6 pins do not protrude from the case
Arduino board is held in place by four small pillars
The Arduino Nano 3D model was created by Andrew Whitham (https://grabcad.com/library/arduino-nano--1).