Thingiverse
Arduino and OLED case by jbaylor
by Thingiverse
Last crawled date: 4 years, 1 month ago
These are three acrylic cases for an Arduino and OLED. They are meant to be inside a box with the face plate attaching it to a control panel.
This was cut from cast 3mm clear acrylic.
The minimum sheet size is: 7.50"x3.25"
Holes are for 3mm bolts.
Stand offs are needed below Arduino (6mm) and between these two sheets (measure what you need after assembly and cut 1" stand offs down to size).
The OLED is soldered on an empty Adafruit Proto Shield.
The redesigned files are for a larger face plate with holes for 3 buttons and a USB. There are two sizes. This design has an additional perf board for the buttons.
The functions for this implementation:http://www.youtube.com/watch?v=BdFwjwNojnQ
If you want the circuits and part numbers, let me know and I can post more details.
This was cut from cast 3mm clear acrylic.
The minimum sheet size is: 7.50"x3.25"
Holes are for 3mm bolts.
Stand offs are needed below Arduino (6mm) and between these two sheets (measure what you need after assembly and cut 1" stand offs down to size).
The OLED is soldered on an empty Adafruit Proto Shield.
The redesigned files are for a larger face plate with holes for 3 buttons and a USB. There are two sizes. This design has an additional perf board for the buttons.
The functions for this implementation:http://www.youtube.com/watch?v=BdFwjwNojnQ
If you want the circuits and part numbers, let me know and I can post more details.