Apple Watch Stand

Last crawled date: 4 years, 4 months ago

This is an apple watch stand to be used with the usb charger.
It can support most types of Apple Watch width with a sliding book-shaped support member.
[design]
The design motif is Dharma.
This stand is designed for the charger that has 8mm depth. There are two type of charger. one comes with the watch that has 8mm depth. Other one is an optional accessory that has 6.6mm depth. When you use the 6.6mm type, please adjust the thickness by inserting a spacer such as paper.
I designed 8mm nut holes in the bottom. If you want to make the stand a little heavier, you can use it.
[print conditions]
ABS (This thing is prone to cracking, so PLA might be better.)
no support
[post-printing]
-If you flatten the bottom of the stand with sandpaper, the stand will become more stable.
-Use M4 CAP screw to fix the sliding book-shaped support member. The length is desirably about 10 mm.
-When using bottom bolts, use M8 x 50mm (max). In some cases it may be necessary to use a tap in the thread.
-It is good to stick sponge rubber etc. on the surface of the support member so that the APPLE watch will not be damaged.
[how to set the charger]
Insert the usb connector of the chager through the hole in the stand face.
With the usb cable down, push the charger body into stand face.
Push the usb cable into the groove on the bottom of the stand.
Attach the support member with the M4 cap screw. Adjust the height of the support members so that the height is just right with the APPLE WATCH.
[how to remove the charger]
Insert a pen from the bottom and press the charger.