Thingiverse
Anycubic Photon, Z Limit Extension, Wham Bam Systems by 1337Slewis
by Thingiverse
Last crawled date: 4 years, 11 months ago
With the addition of a WhamBam Systems Flex Plate, I needed to raise the point where the build plate found home, extending it by at least 2.6mm.
This new limit trigger fits perfectly and does the job.
Just run a 3mm drill bit through the holes after printing and you're done.
Install the trigger tab, and your Home Limit is now higher than standard to allow for a thicker build plate system.
Note: Remove your build plate during the first Homing Test to be safe, and keep your finger over the Emergency Stop. I had no issues whatsoever.
This new limit trigger fits perfectly and does the job.
Just run a 3mm drill bit through the holes after printing and you're done.
Install the trigger tab, and your Home Limit is now higher than standard to allow for a thicker build plate system.
Note: Remove your build plate during the first Homing Test to be safe, and keep your finger over the Emergency Stop. I had no issues whatsoever.