Thingiverse
Anycubic Photon Exhaust Vent by SummitPA
by Thingiverse
Last crawled date: 4 years, 5 months ago
After viewing a similar design, which required an external inline fan which I felt was too expensive and bulky, I designed this model.
The original idea came from Doc Tanner at https://www.thingiverse.com/thing:2877754 if you want to checkout his. He's much better at CAD than I am.
I created this using Tinkercad...and it shows.
This design uses a standard 12v 80mm case fan and 4" flexible dryer vent hose.
The fans can be found on Amazon for as little as $3.
You will also need 4 M3x8 or M3x10 mounting screws as the original screws will be too short to reuse.
I designed the mount with fan mounting screw holes but the fan fits perfectly in the design and doesn't really need the mounting screws.
You can wire the fan with a standard 2.5mm female power jack for easy removal or hard wire it. Pics are included for wiring points.
I was able to access the hard wire points through the vent opening without any more disassembly.
The fan will run as long as the machine is powered on.
The original idea came from Doc Tanner at https://www.thingiverse.com/thing:2877754 if you want to checkout his. He's much better at CAD than I am.
I created this using Tinkercad...and it shows.
This design uses a standard 12v 80mm case fan and 4" flexible dryer vent hose.
The fans can be found on Amazon for as little as $3.
You will also need 4 M3x8 or M3x10 mounting screws as the original screws will be too short to reuse.
I designed the mount with fan mounting screw holes but the fan fits perfectly in the design and doesn't really need the mounting screws.
You can wire the fan with a standard 2.5mm female power jack for easy removal or hard wire it. Pics are included for wiring points.
I was able to access the hard wire points through the vent opening without any more disassembly.
The fan will run as long as the machine is powered on.