Thingiverse
Anycubic Mega-S printing Profile by Exerptus
by Thingiverse
Last crawled date: 4 years, 10 months ago
This is my Cura profie for my AnyCubic Mega-S
I had some issues with the standard setting. Especially with Corners, Tolerance and Top Layer finish. I tried the new Marvin Firmware update but this did not solve the issues. I also tried different Cura Profiles available for download but still hat some issues that.
At the moment I am running my printer with the standard firmware, and TCM2208 V2.0 DIY Stepper drivers installed, because of the noise. Changed the Hardware wireing for the motors to change the direction. But I think this should have no influence on the quality, if you don't has this modification.
This profile is designed for Terrain printing for Miniature Games.
Printer settings:
Layer Height: 0,2 mm
Nozzle: 0,4 mm
Firmware: original, or Marvel
You can modify following:
Wall Line Count: 1 or 2 (not more! This will have a bad influence on top finish)
Extra Infill Wall Count: 1 or more (If you want stronger pats)
Top Layer: 3 or more
Bottom Layers: 3 or more
Following should have no influence and you can choose
Infill Density:
Infill Pattern:
Supports:
Build Plate Adhesion Type:
Print Sequence:
29.11.2020 Did a small update on the profile.
Thanks to Kuehmayer for a lot of help.https://www.thingiverse.com/kuehmayer/designs
I had some issues with the standard setting. Especially with Corners, Tolerance and Top Layer finish. I tried the new Marvin Firmware update but this did not solve the issues. I also tried different Cura Profiles available for download but still hat some issues that.
At the moment I am running my printer with the standard firmware, and TCM2208 V2.0 DIY Stepper drivers installed, because of the noise. Changed the Hardware wireing for the motors to change the direction. But I think this should have no influence on the quality, if you don't has this modification.
This profile is designed for Terrain printing for Miniature Games.
Printer settings:
Layer Height: 0,2 mm
Nozzle: 0,4 mm
Firmware: original, or Marvel
You can modify following:
Wall Line Count: 1 or 2 (not more! This will have a bad influence on top finish)
Extra Infill Wall Count: 1 or more (If you want stronger pats)
Top Layer: 3 or more
Bottom Layers: 3 or more
Following should have no influence and you can choose
Infill Density:
Infill Pattern:
Supports:
Build Plate Adhesion Type:
Print Sequence:
29.11.2020 Did a small update on the profile.
Thanks to Kuehmayer for a lot of help.https://www.thingiverse.com/kuehmayer/designs