Anycubic Kossel Power Supply Wiring Cover and Switch by jbanion

Last crawled date: 3 years ago

This electrical box and switch mount is designed to work with my stock power supply mount linked below. I designed the lid to mount with small screws or ~3mm bolts from the back. You might have to drill these out to fit your desired fasteners. The box mounts to the 2020 with 3 or 4mm bolts and Tnuts. There are now three version of the lid so you can use the octagional, rectangle or no switch.
Printing Instructions: Print the conduit with "build plate only" supports. The box and lid print with normal supports in given orientations.
11-5-17 Rounded edges. Rotated STL's for correct printing positions. Added wedges to minimise supports on the box.
11-6-17 Final updates. Adjusted lit for a smaller gap at the top. Created a no switch lid option. attached a copy of the PS mounting STL.
You can get the switch here:URBEST Inlet Module Plug 5A Fuse Switch Male Power Socket 10A 250V 3 Pin IEC320 C14
If you need wire, this is a good choice:BNTECHGO 14 Gauge Silicone Wire 6 feet [3 ft Black And 3 ft Red] Soft and Flexible 14 AWG Silicone Wire 400 Strands of copper wire Super low electrical resistance for a highly efficient connection
4mm T nuts: https://amzn.to/2raY2jR
Assorted M3 M4 M5: https://amzn.to/2JFOHIB
For more details on the original mount:https://www.thingiverse.com/thing:2479378
Kossel Bed Upgrade Parts from Amazon:
240W Power Supply: http://amzn.to/2ia6Y4R
Plus heat bed 240mm (PLUS): http://amzn.to/2zV1CGh
MOSFET: http://amzn.to/2AnKi9T
MOSFET 2 Pack: http://amzn.to/2nhETOs
Glass Bed 200mm: http://amzn.to/2BB4zJe
Glass Bed 220mm: http://amzn.to/2jAhinl
Glass Bed 240mm (PLUS): http://amzn.to/2i6iluD
If you like my designs why not tip me a dollar or two. Your support will allow me to spend more time on these designs and their variations. Thanks!