Thingiverse
Anycubic Kossel plus damper feet by Ortovox
by Thingiverse
Last crawled date: 4 years ago
These are my Kossel Plus damper feet based on JamesWhite top covers for the Kossel plus.
I changed original design to use separate screws so that they can be printed solid and the rest with infill 20%. And then of course I changed the design to be able to work as feet.
This was done by adding the triagles on top that goes into the base of the printer to make sure the feet does not move and the cross that attaches the damping rubber feet in the bottom.
The fit for the screws can be very tight but should work with some violence :) .
The design is made to be used with vibration damping feet for washing machines by Curaqua from the store www.jula.se in sweden these feet
There are similar damper feet on ebay that are close in size like these but I don't know if they will fit.vibration damper feet
I changed original design to use separate screws so that they can be printed solid and the rest with infill 20%. And then of course I changed the design to be able to work as feet.
This was done by adding the triagles on top that goes into the base of the printer to make sure the feet does not move and the cross that attaches the damping rubber feet in the bottom.
The fit for the screws can be very tight but should work with some violence :) .
The design is made to be used with vibration damping feet for washing machines by Curaqua from the store www.jula.se in sweden these feet
There are similar damper feet on ebay that are close in size like these but I don't know if they will fit.vibration damper feet