Anycubic I3 Mega Cable Chain by RTamer

Last crawled date: 4 years, 3 months ago

I made this one specifically to be large enough to fit the connector (hotend side). The link is 24.5mm x 22mm. The middle hole is 17,5mm x 10mm, and makes it easy for the connector to pass through. For the end connector (extruder side), you will need a 3mm screw, as I used a tapped hole that was already there. For the end connector (hotend side), you will need 2x 3mm screws and nuts, also using the two holes that were already there. I also printed 25 links and it works well. No more squishing the cable between the extruder motor.