Anycubic enclosure bottom airflow by diegobobcat

Last crawled date: 4 years, 5 months ago

This is my simple solution when the printer is fitted into enclosure box. Printing hot air went inside the PCB and power supply chassis (no good* the chassis fan was always on and stressed for long time)! Then if bottom is airflowed it should not refresh air in the enclosure. See the pictures to better undesrand. Two 220v low noise fan are spotted on the enclosure base in particular position. One direct on the power supply fan (it push air ) the other one fan some cemtimeters far pushing air outside the chassis. The glued 3d Printed parallelepipeds are sized to seal the bottom of the printer. Then aluminium tape is used to close the original holes on base frame. That's it and sorry for my horrbile english language. Hope this will help users.