Anycubic 4Max [操作台]LCD table BOX by roromiao

Last crawled date: 4 years, 2 months ago

这是我为4max 设计的操作台.
也是我在T站上传的第一个模型
建议翻转模型 让液晶屏正面朝向-Z 这样就不用打支撑了。
螺丝的话 原配的就行 如果长度不适合
可以在附近五金店寻找3mm 螺丝 来固定。
内存卡位置放宽了一些 可以兼容长短螺丝固定液晶屏不会导致SD卡位置出错。
最后 希望大家喜欢。。谢谢
我在文件里附上了原始的CAD设计图。。大家可以自行修改匹配
by 小施 2018、5、30
软件 Cura/S3D
层高 0.2-0.3
速度 50-60mm
Attention!
The following is the automatic translation of the paragraph, there may be an error
This is the console I designed for 4max.
It was also the first model I uploaded on the T site
It is recommended to flip the model so that the LCD is facing -z so that it doesn't have to be supported.
If the screw is out of place if the length is out of place
Look for 3mm screws in the nearby hardware store.
The position of the memory card is relaxed so that the LCD screen can be fixed with compatible length screws without causing SD card position error.
I hope you enjoy it. thank you
I attached the original CAD design drawing to the document. You can modify the match yourself
By xiaoshi 2018/5/30
Software Cura/S3D
The height of 0.2 to 0.3
Speed of 50 to 60 mm