Thingiverse
Anet Mainboard and Mosfet Cases for External Enclosures by MattKi
by Thingiverse
Last crawled date: 4 years, 2 months ago
This project is really 3 items grouped together for convenience:
A housing for the Anet mainboard with the following design features:
mounting position for a 60mm fan
pin to allow you to use the reset microswitch without opening
interior holes through which cables can be routed through holes in your enclosure wall into your enclosure of choice
exterior holes for power supply and mosfet enclosure wiring.
slots around the top right corner for routing of the display ribbon cable
A housing for two fairly standard mosfet modules with design features as follows:
entry hole for wiring from an adjacent mainboard holder
external holes for wiring the signal connections from above and for making power connections
internal holes to allow routing of cables carrying power to the heated bed and heater cartridge if desired.
A 60mm fan guard with following features:
holes in the appropriate places
an attractive (subjectively) 5 line based pattern.
Pictures illustrate how I chose to install this on my enclosure. It has the advantage of using much less material to print and each of the parts is significantly smaller than the footprints of either of my other designs (one designed to be mounted on printer and the other as an all in one external enclosure).
If you print this and like it you can encourage me to continue creating new designs by liking the design, posting your make and even remixing the design to suit your specific purpose.
If you have money to spare after you've taken care of the welfare of any family, friends and charities and causes you choose to support you're also welcome to send over a tip. Please note that while appreciated, support of any kind is not a requirement for you to make use of this design.
A housing for the Anet mainboard with the following design features:
mounting position for a 60mm fan
pin to allow you to use the reset microswitch without opening
interior holes through which cables can be routed through holes in your enclosure wall into your enclosure of choice
exterior holes for power supply and mosfet enclosure wiring.
slots around the top right corner for routing of the display ribbon cable
A housing for two fairly standard mosfet modules with design features as follows:
entry hole for wiring from an adjacent mainboard holder
external holes for wiring the signal connections from above and for making power connections
internal holes to allow routing of cables carrying power to the heated bed and heater cartridge if desired.
A 60mm fan guard with following features:
holes in the appropriate places
an attractive (subjectively) 5 line based pattern.
Pictures illustrate how I chose to install this on my enclosure. It has the advantage of using much less material to print and each of the parts is significantly smaller than the footprints of either of my other designs (one designed to be mounted on printer and the other as an all in one external enclosure).
If you print this and like it you can encourage me to continue creating new designs by liking the design, posting your make and even remixing the design to suit your specific purpose.
If you have money to spare after you've taken care of the welfare of any family, friends and charities and causes you choose to support you're also welcome to send over a tip. Please note that while appreciated, support of any kind is not a requirement for you to make use of this design.