Anet A8 Moving Fan Bracket by twistedfab13

Last crawled date: 3 years ago

This is a remix to Anet A8 Extruder Fan Modification V2 by hadoko. I put a little more meat on the front bracket. The side bracket now holds a BL-Touch sensor.
Use the settings from OderWat BL-Touch setup.https://www.thingiverse.com/thing:2091529
The only thing is that you will need to change the offsets for this bracket. I had them as follows and they worked just fine:
define X_PROBE_OFFSET_FROM_EXTRUDER 14 // X offset: -left +right [of the nozzle]
define Y_PROBE_OFFSET_FROM_EXTRUDER 53 // Y offset: -front +behind [the nozzle]
define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]
You travel limits will be different also. This is what I had for a 200x200 bed:
// Travel limits after homing (units are in mm)
define X_MAX_POS 220
define X_MIN_POS -33
define Y_MAX_POS 220
define Y_MIN_POS -10
define Z_MAX_POS 240
define Z_MIN_POS 0