Thingiverse
Anet A3 Heat Bed Wire Relief by CrypticCircuits
by Thingiverse
Last crawled date: 4 years, 3 months ago
This bracket clips across the Z axis supports behind the heat bed. Ziptie'n the heat bed wiring to this, relieves the stress on the clip and wiring caused by the Z axis movement.
Things needed:
2 - 4 inch(10cm) zipties.
Tip: Install the side ziptie before installing the bracket as show in the photo.
Also make sure the heat bed wiring has enough slack coming from the bottom of the printer. I had to cut a ziptie under the printer to give slack to the wiring that was extremely tight.
Things needed:
2 - 4 inch(10cm) zipties.
Tip: Install the side ziptie before installing the bracket as show in the photo.
Also make sure the heat bed wiring has enough slack coming from the bottom of the printer. I had to cut a ziptie under the printer to give slack to the wiring that was extremely tight.