Thingiverse
Amiga Gotek OLED 128x64 0.96" display with rotary encoder
by Thingiverse
Last crawled date: 5 years, 3 months ago
Amiga 500 128x64 0.96" OLED display case utilising a rotary encoder.
Mounts to grill on the rear of the Amiga 500 (measured for PAL A500)
I found the best way to print this was to have the face down.
To get the pins to sit 90' I bent them with the plastic locator in place, then broke up the locator with flush cut wire snips. Care must be taken as you can easily break the board or screen.
The retaining clip does not touch the OLED display, you need to use foam tape to help secure it. I designed it this way as I was afraid of the display cracking with the pressure from the clip.
The design is for the OLED display with round mount holes, I do not own the elongated hole type so it may/maynot fit that model.
Don't forget to update your config file ff.cfg to suit the 128x64 display (display-type = oled-128x64)
Mounts to grill on the rear of the Amiga 500 (measured for PAL A500)
I found the best way to print this was to have the face down.
To get the pins to sit 90' I bent them with the plastic locator in place, then broke up the locator with flush cut wire snips. Care must be taken as you can easily break the board or screen.
The retaining clip does not touch the OLED display, you need to use foam tape to help secure it. I designed it this way as I was afraid of the display cracking with the pressure from the clip.
The design is for the OLED display with round mount holes, I do not own the elongated hole type so it may/maynot fit that model.
Don't forget to update your config file ff.cfg to suit the 128x64 display (display-type = oled-128x64)