Thingiverse
Allspool Spool Holder by Microphobe
by Thingiverse
Last crawled date: 4 years, 3 months ago
I got tired of spools not fitting snugly and rocking and jerking due to not being held securely on the spool holders because of different size holes in the center.
If you have suggestions or requests to change this please let me know.
The tolerance for the base and the mate is 0.1mm, this is deliberate and it will be very stiff when you first try to thread it on, as you work it down it will smooth out the jagged edges from the 0.2 layer height and will run very smoothly. I can spin mine all the way off or on with a single twist.
The version uploaded works well but I am making a one sided stand to make getting it off and on easier. The current spool holder will fit the new stand.
I don't normally ask this but feel free to throw a buck my way, I burnt almost an entire roll of filament developing/perfecting these.
30/07/18 - Added updated version (2.1) of single arm heavy duty to include a tab at the rear to reduce forward sliding on wobbly tables.
08/04/18 - Added the revised more finger friendly version of the spool holder mate.
04/04/18 - Added a slightly thicker version of the heavy duty single side spool holder, 5mm thicker on the spool holder arm.
19/03/18 - Added heavy duty version of single side spool holder for the bigger than 1kg users. The whole thing uses about 60m of filament
13/03/18 - Added single side holder.
If you have suggestions or requests to change this please let me know.
The tolerance for the base and the mate is 0.1mm, this is deliberate and it will be very stiff when you first try to thread it on, as you work it down it will smooth out the jagged edges from the 0.2 layer height and will run very smoothly. I can spin mine all the way off or on with a single twist.
The version uploaded works well but I am making a one sided stand to make getting it off and on easier. The current spool holder will fit the new stand.
I don't normally ask this but feel free to throw a buck my way, I burnt almost an entire roll of filament developing/perfecting these.
30/07/18 - Added updated version (2.1) of single arm heavy duty to include a tab at the rear to reduce forward sliding on wobbly tables.
08/04/18 - Added the revised more finger friendly version of the spool holder mate.
04/04/18 - Added a slightly thicker version of the heavy duty single side spool holder, 5mm thicker on the spool holder arm.
19/03/18 - Added heavy duty version of single side spool holder for the bigger than 1kg users. The whole thing uses about 60m of filament
13/03/18 - Added single side holder.