Thingiverse
Airsoft MP5 V2 AEG/HPA Adjustable Trigger
by Thingiverse
Last crawled date: 5 years, 3 months ago
Airsoft AEG/HPA adjustable Trigger designed for MP5 models. One can adjust the pull length and position of the trigger with two screws. This is catered towards the HPA switch and MOSFETs that are not using normal switch assembly.
Notice: Be extra careful with the position adjustment screw, there is not that much room for threads. Noticed that using brittle filament it is easy to snap the area. I will look into this
Work in progress
V17
-Added reinforcements for not that calibrated printers
V16
Reinforcements
M3x15 Set Screw for the Main Axle
M3x10 Set Screw for the pull adjustment
M2.5 Position Adjustment
V12
Parts needed:
M3x15 Set Screw for the Main Axle
M3x10 Set Screw for the pull adjustment
(Optional)
M2 set screw for trigger position adjustment
Use 3mm drill to even out the holes or tap them with M3 set for (M2 for small adjustment hole in v12)
Notice: Be extra careful with the position adjustment screw, there is not that much room for threads. Noticed that using brittle filament it is easy to snap the area. I will look into this
Work in progress
V17
-Added reinforcements for not that calibrated printers
V16
Reinforcements
M3x15 Set Screw for the Main Axle
M3x10 Set Screw for the pull adjustment
M2.5 Position Adjustment
V12
Parts needed:
M3x15 Set Screw for the Main Axle
M3x10 Set Screw for the pull adjustment
(Optional)
M2 set screw for trigger position adjustment
Use 3mm drill to even out the holes or tap them with M3 set for (M2 for small adjustment hole in v12)