Airbox Vent - For Motorcycles, ATV and Much More by ItsProtonBob

Last crawled date: 3 years ago

This is an Airbox Vent that you can print at home to increase airflow to your motor. It will accommodate 5/8 thick air filter foam. Cut 1 inch circles out of the foam sheet for a snug fit in the 0.875" barrel, oil them, and pop them into place. They are designed to fit in 1" holes drilled into your airbox lid or sides. The fit should be snug to prevent particulate from making it past these mini-filters. I also suggest adding a thin bead of silicone to the mating flange to ensure a good seal to the airbox or lid. These increase the amount of airflow to your airbox, and allow your engine to breathe more freely, allowing for faster acceleration on your motorcycle, ATV, dirtbike, or whatever it may be.
Designed in Autodesk Fusion 360