Thingiverse
Air pruning pot for bonsai - Variation by sokutaban
by Thingiverse
Last crawled date: 4 years, 3 months ago
Made this planter based on GillyBot3D's original design for my mom who wanted two pots for her plants. Simplified the design for cost and printability. Added a water catcher for runoff that includes supports and centering brackets. Both pieces have feet for aeration and aesthetics.
The print time, in draft mode (0.2mm layer thickness), for the planter was approximately 22 hours at 45mm/s (silent running on my cr-10) and the water catcher was approximately 12 hours.
Planter size is 6 inches (152.400 mm) across by 4.177 inches (106.100 mm) tall. The water catcher base is 6.767 inches (172.400 mm) wide by 1.122 inches (28.500 mm) tall, leaving a 0.315 inch (8 mm) gap between the planter and the water catcher's inside edge. All walls are 0.079 inches (2 mm) thick. Both bases are 0.118 inches (3 mm) thick. Feet are 0.059 inches (1.5 mm).
If you like the design please consider tipping me, donating at:paypal.me/ShrinkRayme
or tipping the source inspiration creator.
Thanks!
The print time, in draft mode (0.2mm layer thickness), for the planter was approximately 22 hours at 45mm/s (silent running on my cr-10) and the water catcher was approximately 12 hours.
Planter size is 6 inches (152.400 mm) across by 4.177 inches (106.100 mm) tall. The water catcher base is 6.767 inches (172.400 mm) wide by 1.122 inches (28.500 mm) tall, leaving a 0.315 inch (8 mm) gap between the planter and the water catcher's inside edge. All walls are 0.079 inches (2 mm) thick. Both bases are 0.118 inches (3 mm) thick. Feet are 0.059 inches (1.5 mm).
If you like the design please consider tipping me, donating at:paypal.me/ShrinkRayme
or tipping the source inspiration creator.
Thanks!