Thingiverse
Aerogarden Rootsaver (Splitable/re-usable pod)
by Thingiverse
Last crawled date: 5 years, 9 months ago
Designed with the intention of maximizing plant size in the Aerogarden while minimizing root damage when transplanting. Split along perforated seam (if necessary) to remove plant and snap back together with printed in place iris cap.
RootSaver3 (Update):
.2 layer height, 5% infill, no supports - gently squeeze around perimeter of cap to release
Original:
.12 layer height, 100% infill for RootSaver, no supports
.12 layer height, 5-15% infill Top, Bottom and Clip
Setup:
-Aerogarden Harvest
-Pawfly Nano air pump/stone
Disclaimer: My first time using an aerogarden and pretty new to 3d printing but it's going well so far!
RootSaver3 (Update):
.2 layer height, 5% infill, no supports - gently squeeze around perimeter of cap to release
Original:
.12 layer height, 100% infill for RootSaver, no supports
.12 layer height, 5-15% infill Top, Bottom and Clip
Setup:
-Aerogarden Harvest
-Pawfly Nano air pump/stone
Disclaimer: My first time using an aerogarden and pretty new to 3d printing but it's going well so far!