Adjustable RC Car Stand w/ Shocks Station 3d model
3dmdb logo
Thingiverse
Adjustable RC Car Stand w/ Shocks Station

Adjustable RC Car Stand w/ Shocks Station

by Thingiverse
Last crawled date: 4 years, 2 months ago
This is an RC Car Stand that I built to work on my Traxxas E-Revo 1/16 (it's sized so that it fits the MERV perfectly, but should be able to hold larger models as well).
Features:
Freely rotating (360 degrees)
Adjustable height (turn the M20 nut to lift / lower - independent of rotation)
Hole sets (4) for holding shocks: 10mm, 13.5mm and 15mm
Holes to hang shocks upside down for draining oil (placed above oil trays for dripping)
Multiple trays for holding parts (including one separated for front / back)
Depending on your printer and settings, prints in around 15h and uses about 140g of filament (which brings cost at about $3, so much cheaper than ordering, including AliExpress)
I used some strips of rubber I had laying around for stability, and you can use furniture feet stickers from any DYI store as well.

Tags