Thingiverse
Adjustable E3D V6 / Volcano Layer Fan by urw
by Thingiverse
Last crawled date: 4 years, 1 month ago
A collaboration between thatch and myself. A lightweight layer fan that fits both E3D V6 and Volcano length heater blocks. Inspired by Tom114's remix of Prusa MK2 fan.
Everything should print without supports, however there is a trap nut on the blower bracket that may require them for your machine. The blower bracket can be slid up and down along a half dovetail to the desired height before tightening into place.
Requires:
50mmx15mm radial fan
E3D cold zone fan and plastite screws
(1) M3x35mm cap head screw (longer can work)
(1) M3x20mm cap head screw (longer can work)
(2) M4x20mm screws for the blower
(2) M3 nuts
Everything should print without supports, however there is a trap nut on the blower bracket that may require them for your machine. The blower bracket can be slid up and down along a half dovetail to the desired height before tightening into place.
Requires:
50mmx15mm radial fan
E3D cold zone fan and plastite screws
(1) M3x35mm cap head screw (longer can work)
(1) M3x20mm cap head screw (longer can work)
(2) M4x20mm screws for the blower
(2) M3 nuts