Abajaur Lamp - Ikea Harte by HerbalPT

Last crawled date: 3 years, 1 month ago

This is a very simple abajur for the Ikea Harte lamp.
The light from the LEDs was very focused and strong. This helps to make the light less bright and to obtain a better distribution over the desk.
This abajur has two parts, the main body and the base.
The base should be printed separately from the main body and then glued together.
The holes were set 0,2 mm above the nominal dimension of the lamp body. Be aware that heavily depends on your printer settings if these parts will fit perfectly in your lamp, if it doesn’t, please be patient and use sandpaper to have the hole dimension a few tenths of mm wider until the proper fit is achieved.
Thank you :)