Water Fog Net Challenge 3d model
Warning. This content is not moderated and could be offensive.
weapons
3dmdb logo
GrabCAD
Water Fog Net Challenge

Water Fog Net Challenge

by GrabCAD
Last crawled date: 1 year, 9 months ago
Fog net support set for :
- resisting a wind pressure of 600 N/m² (Vb=70mph=31,3 m/s), with security factor of 1,5
- have less than 2mm max displacement under the same wind with a factor of 1
- allow to position the net from 1m to 3 m (net base)

Must say this one got me! This design is too bulk but i do not have enough data :
- what is the minimal distortion allowed on the net ?
- can i glue, can it be weld, what pressure can i apply on it ?
- what is the porosity of the net (for the wind effects)
- Is the use of concrete supports on the ground possible ?

I try to use common steel beams and screws. There's a lot of part but this will allow an easy transport and almost all assembly only need hex key .

Tags