Tilta Nucleus Nano clamp adapter 3d model
Warning. This content is not moderated and could be offensive.
m4
3dmdb logo
Thingiverse
Tilta Nucleus Nano clamp adapter

Tilta Nucleus Nano clamp adapter

by Thingiverse
Last crawled date: 4 years ago
This clamp adapter is meant to be screwed into a single-rod clamp or super clamp for easy attaching the Nucleus Nano remote to you rig.
It's just pushed in with now additional locking, it's tight enough to not just slide out. Because there's no lock, it's super simple, prints fast and the remote can easily be taken off or stored away again.
The 20mm version works for common super clamps, which can easily be attached to 15mm rods as well as your tripod, jib, gimbal, slider base or whatever.
The 18.5mm version works with the generic single rod clamps, but measure yours upfront.
INSTRUCTIONS
Next to a rod adapter or super clamp, you will need a 1/4" counter sunk screw to attach it, as well as some self-adhesive felt or velvet.
The self-adhesive is needed to make the holder tight enough and the operation smooth.
Print as you like, you don't need much infill (I used 25%), layer height depends on how smooth you want it - for me, 0.2 is enough :)

Tags