Peristaltic pump by MarcoKl

Last crawled date: 3 years, 3 months ago

Peristaltic pump for NEMA 17 stepper motor
https://youtu.be/LoKCXN6wbZMhttps://youtu.be/zMSOZYFtSEs
Use base.stl if you want no mount and base_wallmount.stl to mount it somewhere.
Use cable strips to fix the tubes on both ends. The pump can run in both directions.
Requirements:
22mm / 08mm bearing
2.5 x 5 mm silicon tube
your favourite stepper driver
Arduino, ESP or similar
Features:
Depends on your code.
For example:
I use it with MQTT via WLAN to add algicide to my pool.
Printing resolution is not mandatory.
You should put a rubbery tape inside the frame where the tube is placed to take care of the tube.