GrabCAD

Pentalobe Squarepants 5.8 gHz FPV antenna

by GrabCAD
Gig to make a five lobe LHCP 5.8gHz (5780hz) Rx/Tx antenna set for FPV.

Use the bending tool to make the lobes and a balun (26mm).

Secure the lobes with five M3x5mm screws while soldering the lobes to the RG402 cable. Then twist the balun around a 6mm rod and solder it to the RG402 making sure it is isolated with heat shrink. If you do not know what you are doing get a set of Airblades from IBCrazy.

Tags