PCBGRIP Oscilloscope Clamp Rigol Upper 3d model
Warning. This content is not moderated and could be offensive.
nazi
3dmdb logo
GrabCAD
PCBGRIP Oscilloscope Clamp Rigol Upper

PCBGRIP Oscilloscope Clamp Rigol Upper

by GrabCAD
Last crawled date: 1 year, 9 months ago
I designed this clamp to hold the probes for my Rigol scope and work with the PCBGRIP system. The hole in the end of the clamp is designed to accept a M3x0.5 male thread. The model does not contain the internal thread, just a 2.5mm diameter hole. You can either tap the hole or just thread a M3x0.5 male thread into the clamp after it is printed.

The outside diameter of the Rigol probe is approximately 11mm and the internal diameter of the clamp is 10.5mm.

Tags