Hairspray Pump

Last crawled date: 6 years, 1 month ago

Please read the safety concern section below

Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools.

I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray.

I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans.

NOTE
If It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole, mists perfectly now

1) Print this out
2) Pull off the spray nozzle on your bottle of hairspray
3) Snap this into place
4) ...
5) You're done!

Now, I have a little sheet of paper towel folded next to the can, and every time I want to apply some hairspray to the bed single handedly, I just take the paper towel, and press down on the mouth quickly, and wipe that on the bed. Nice single even coating of hairspray!