Thingiverse
9 Character Smash Brothers Amiibo Plinth by Metzhara
by Thingiverse
Last crawled date: 4 years, 4 months ago
This is a massive print!
First layer is 24mm high.
Second layer is 88mm high.
Third layer is 152mm high.
Amiibo holes are set to 49.5mm as this fits most amiibos well enough with a few being snug.
This print will take a few days to do correctly. This is a warning.
NOTE: I will post my first successful print. I have no concerns about it printing but it is almost 3 days with the settings I will be trying.
I willl use supports to keep the Smash logos looking good.
I also added a little "bolt" look a la Super Mario Bros 3. This led to the rounded look.
I liked the classic Nintendo logo so I used that for the front.
All face extrusions outside of the amiibo holes themselves are .8mm.
First layer is 24mm high.
Second layer is 88mm high.
Third layer is 152mm high.
Amiibo holes are set to 49.5mm as this fits most amiibos well enough with a few being snug.
This print will take a few days to do correctly. This is a warning.
NOTE: I will post my first successful print. I have no concerns about it printing but it is almost 3 days with the settings I will be trying.
I willl use supports to keep the Smash logos looking good.
I also added a little "bolt" look a la Super Mario Bros 3. This led to the rounded look.
I liked the classic Nintendo logo so I used that for the front.
All face extrusions outside of the amiibo holes themselves are .8mm.