Thingiverse
8266 case (NodeMCU)
by Thingiverse
Last crawled date: 5 years, 9 months ago
This is a case I designed to fit the NodeMCU board.
Buy the
Node MCU here.
It is simple to print and the board should fit fine, if it doesn't, there is a fusion 360 file for you to edit.
If the tolerances on the holes don't fit, you can either adjust the file and reprint, or you can heat up a wire and melt the holes larger.
No supports are needed. If the chamfers on the bottom are too extreme, you can print a flat bottom.
To remove the board from the case, you need to push the pins from the opposite side with a small pick.
Buy the
Node MCU here.
It is simple to print and the board should fit fine, if it doesn't, there is a fusion 360 file for you to edit.
If the tolerances on the holes don't fit, you can either adjust the file and reprint, or you can heat up a wire and melt the holes larger.
No supports are needed. If the chamfers on the bottom are too extreme, you can print a flat bottom.
To remove the board from the case, you need to push the pins from the opposite side with a small pick.