Thingiverse
5" LCD Touch Display Mount for Prusa i3 MK2 by DS_Desgin
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a Holder + Case for a 5inch LCD Screen with HDMI and USB touchscreen.
It should fit very snugly on to the frame of the Orginal Prusa i3.
Please read the Post-Printing section before you start printing !
After using a 3,5 inch TFT Screen with this Holder i made :https://www.thingiverse.com/thing:2146541
it was time for something bigger...
Also check out the tutorial on Github how to Setup Octo print on a RaspberryPie with jessie :
( https://github.com/foosel/OctoPrint/wiki/Setup-on-a-Raspberry-Pi-running-Raspbian ).
If you have any questions please do not hesitate to ask me.
Don't forget to tell me about your prints in the Comments and leave a picture of your setup.
It always makes me very happy to see your results.
Happy Printing ! :D
It should fit very snugly on to the frame of the Orginal Prusa i3.
Please read the Post-Printing section before you start printing !
After using a 3,5 inch TFT Screen with this Holder i made :https://www.thingiverse.com/thing:2146541
it was time for something bigger...
Also check out the tutorial on Github how to Setup Octo print on a RaspberryPie with jessie :
( https://github.com/foosel/OctoPrint/wiki/Setup-on-a-Raspberry-Pi-running-Raspbian ).
If you have any questions please do not hesitate to ask me.
Don't forget to tell me about your prints in the Comments and leave a picture of your setup.
It always makes me very happy to see your results.
Happy Printing ! :D