4 IN CYCLONE SEPARATOR

Last crawled date: 4 years, 3 months ago

4 IN VACUUM CYCLONE
300X300X400 REQUIRED PRINT VOLUME
Big volume and long prints! Recommend using a nozzle of 1.0mm to speed up the print process!
For a similar version - 4 inches hose, however with inside walls aligned face to face, so...no extra turbions to the process off cyclone separation see: https://www.thingiverse.com/thing:3971669
For a smaller version - 40mm hose see: https://www.thingiverse.com/thing:3183875
For a smaller version - 2inches hose see: https://www.thingiverse.com/thing:3972584
For a metal version - 4 inches hose see https://www.thingiverse.com/thing:3811097
Upgrade:
10 11 2019
New Cone and Reduced Body
Add Cyclone Collector Connector.
Connections have build in place the plate adhesion - 0.6X4 - what need to be removed after print.
Cyclone body 2nd version have a Print Without Support - bracket and a reinforcement ring on front connection and 3th version is a reduced one!
Cyclone is design to be secured with two M8 countersunk bolts, they are also used to discharge all electrostatic accumulation! Have a flat-bar or a striped electrical conductor between them (on the outside of the Cyclone) and connect it to the ground.
If the Cyclone is not connected directly on the dust drum cover, and is require to use a hose between them, in order to have easy access to the drum... see the Cyclone Collector Connector.
For the dust drum connector, if the Cyclone Collector Connector is to big, use the parts from the Wall Penetration: https://www.thingiverse.com/thing:3960822
DESIGN TO PRINT WITHOUT SUPPORT! MOSTLY! By Costa