Thingiverse
3M 5N11 N95 Filter Mask by 3D_Now
by Thingiverse
Last crawled date: 5 years, 8 months ago
This is a mask that can be 3d printed to fit a 3M 5N11 N95 filter.
Directions:
Print both parts in PETG and disinfect with IPA when done.
Purchase and install 5N11 filter in cover: https://bit.ly/2JlBaYE
Clip both parts together while handling with gloves.
Cut 2 pieces of knit elastic band 16 inches long by 1/4 inches wide.
Tie both strands permanently on right 2 holes and with slip knot on left 2 holes for adjustability.
This model is still a work in progress and was not tested to ensure medical grade standards. Please use at your own risk.
Directions:
Print both parts in PETG and disinfect with IPA when done.
Purchase and install 5N11 filter in cover: https://bit.ly/2JlBaYE
Clip both parts together while handling with gloves.
Cut 2 pieces of knit elastic band 16 inches long by 1/4 inches wide.
Tie both strands permanently on right 2 holes and with slip knot on left 2 holes for adjustability.
This model is still a work in progress and was not tested to ensure medical grade standards. Please use at your own risk.