Thingiverse
3D Printed DIY Flight Simulator Pedals (Rudder & Brake) Using Arduino by dvilardi
by Thingiverse
Last crawled date: 4 years ago
MY YOKE:
https://www.thingiverse.com/thing:4855469
Pedal Controller For Flight Simulator (Rudder & Brakes) Using Arduino
3D printable Pedal controls for Flight Simulator using Arduino.
Manual, wiring scheme, arduino code and setup instructions attached in the PDF file.
Assembly instructions at https://youtu.be/B3WRmVOTyvY
NOTE: some STL parts were created at a 20° angle from the base.
Materials needed
PLA filament (or any other filament your printer accepts)
3 B10K potentiometers
1 arduino uno (original with Atmel microcontroller and DFU/reset pins)
MDF Wood base and screws
Wires
Springs
https://www.thingiverse.com/thing:4855469
Pedal Controller For Flight Simulator (Rudder & Brakes) Using Arduino
3D printable Pedal controls for Flight Simulator using Arduino.
Manual, wiring scheme, arduino code and setup instructions attached in the PDF file.
Assembly instructions at https://youtu.be/B3WRmVOTyvY
NOTE: some STL parts were created at a 20° angle from the base.
Materials needed
PLA filament (or any other filament your printer accepts)
3 B10K potentiometers
1 arduino uno (original with Atmel microcontroller and DFU/reset pins)
MDF Wood base and screws
Wires
Springs