Thingiverse
32mm spool mount for Vellemann Vertex K8400 by MSpencer
by Thingiverse
Last crawled date: 4 years, 8 months ago
This is a spool adapter which can be applied on the original spool mount at each side of your Vertex K8400 printer.
Just remove the two black halfes of your spool mount and apply this piece directly onto the bearings below.
It is a little cylinder with spikes to keep the cylinder from slipping from the screw and bearings. You might have to use a file to make it fit an slip firmly over these bearings.
I used this one for my Taulmann Nylon spools. Please check if the 32mm diameter is still valid or if your spools have an even smaller center diameter now.
Just remove the two black halfes of your spool mount and apply this piece directly onto the bearings below.
It is a little cylinder with spikes to keep the cylinder from slipping from the screw and bearings. You might have to use a file to make it fit an slip firmly over these bearings.
I used this one for my Taulmann Nylon spools. Please check if the 32mm diameter is still valid or if your spools have an even smaller center diameter now.