3-pin fan connector (molex) by jpnurro

Last crawled date: 4 years ago

The connector body for the 3-pin fan cable. This unit doesn't require any additional metal parts.
Strip wire ends 5mm put them in to the holes (note the order) and bend them through the canals. The locking bar might require a bit force (depending cable size), press the end e.g. towards table (no tools needed).
When the connector is it's place, the motherboard's connector body secures the assembly.
Obviously the original connector with the tin parts is the superior solution. This unit should be used only for the secondary applications.
(Tip: print locking bar 'B' the right side visible surface downwards to get better layer direction strengt)