Thingiverse
3 hybrid planks, RC airplanes. by _Dave
by Thingiverse
Last crawled date: 4 years, 6 months ago
Print the nose for the motor bolt pattern you have and a rear half, Joiner and vertical stab.
Typical motors that may fit are the 1806 and 2206 quad motors, a Blue Wonder type motor and a 2212 conventional 50 gram motor.
So print a nose tail vertical stab and joiner. The wing is held on with rubber bands. The rear dowel pin also holds in the vertical stab.
The wing I used was a 24"x8" kfm1 foam board wing. It has good characteristics for this model. Make the area under the rear two layers to add a bit of stiffness but mainly to make the top surface of the wing flat.
With the small motor and smallish battery the plane is under 250 grams With a 50g motor and 2500mah battery it is 380 grams.
Typical motors that may fit are the 1806 and 2206 quad motors, a Blue Wonder type motor and a 2212 conventional 50 gram motor.
So print a nose tail vertical stab and joiner. The wing is held on with rubber bands. The rear dowel pin also holds in the vertical stab.
The wing I used was a 24"x8" kfm1 foam board wing. It has good characteristics for this model. Make the area under the rear two layers to add a bit of stiffness but mainly to make the top surface of the wing flat.
With the small motor and smallish battery the plane is under 250 grams With a 50g motor and 2500mah battery it is 380 grams.