2Pin connector substitution sleeve by Deln555

Last crawled date: 3 years ago

A sleeve , substitute for 2 pin connector.
Excellent fit for JST-XH 2pin (XHP-2) or equiv.
(used as fans/sensors/etc. connector in most of PCBs I know)
I made this for Anycubic Trigorilla's fan port.
housing: 5.0 x 7.3 mm
contact hole: 2.5 x 3.3 mm x2 ( with this large hole, you can use many type of contact tip.
Wall thickness is just 0.4mm, so this must be printed with "Thin wall option".　
Attention
This is just "Sleeve", focused on insulation.
There are no lock between housing and contact.
Must push contacts into the bottom of the connector after connecting.
And be careful to not pull the contacts.
Or, use glue.
Background
Because getting TMC2208 motor drivers, I wanted to add PCB cooling fan.
However, my only surplus fan was 3 pin type 40x40x10 with thick contacts.
So I made this sleeve as substitute for XH 2pin housing using the contacts.