Thingiverse
24mm Ground Glass Joint Stand for Glass Symphony by scarletwonder
by Thingiverse
Last crawled date: 4 years, 5 months ago
This is a stand made for the Glass Symphony, but it should work with any 24mm male ground glass joint.
This was successfully printed in porcelain via shapeways and works/fits very well.
I also included the cone I use to make joints in models. The top has a diameter of 24.5mm and tapers down correctly (1:10 ratio) to give a snug fit. The height is longer than the standard ground glass joint, just remove what you don't need. If you resize the length make sure it the diameter/width doesn't change. I made it slightly bigger than 24mm to accommodate glass joint size variation and the width glaze adds.
This was successfully printed in porcelain via shapeways and works/fits very well.
I also included the cone I use to make joints in models. The top has a diameter of 24.5mm and tapers down correctly (1:10 ratio) to give a snug fit. The height is longer than the standard ground glass joint, just remove what you don't need. If you resize the length make sure it the diameter/width doesn't change. I made it slightly bigger than 24mm to accommodate glass joint size variation and the width glaze adds.